CROSSRUNNER 250 Manuel d'utilisateur télécharger pdf (Page 102)

(III)Inspection content

1.Check if the steering bar is cracks bent, is

bent or damaged. If it is, replace it.

2.Inspect if the steering vertical column weld-

ing assy is bent or damaged. if it is, replace it

In order to avoid decreasing the performance

of steering vertical column, if it is bent do not

straighten it frocefully.

3.Inspection

Steering vertical column holder¢Ùand seal ring

¢Ù¢Ú .If they are worn or damaged, replace it.

4.Inspection:

If the tension rod ¢Ùis bent or damaged. If

they are, replace them.

5.Correcting:

The displacement of end head of steering ten-

sion rod ball pin assy(Refer to as pin ballas

shown on the drawing).If the free clearance

is found on the ball pin end head ,replace the

ball pin. If the part around the ball pin end head

is uneven, also replace it.

If there is convex point, wear, damage on the

core surface of ballpin end head, replace it.

Warning

-96-

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 227 228

Pas de commentaire

CROSSRUNNER 250 Manuel d'utilisateur Page 102